C605 Specifications

The C605 is a crane that can effortlessly place glass on the second floor. It has a very favourable weight-to-capacity ratio due to the use of a slewing ballast. This type can also be easily transported with a service van. Is has a knuckle in the boom and can be optionally equipped with a fly jib and/or winch. The fly jib makes it possible to lift the load over a balcony and place it up to around three metres in from the edge. The fly jib can be removed in 5 minutes, further increasing the lifting capacity.

 

C605 Full Specifications
Crane capacity capacity: 1.2t x 2.73m
Max working radius max: 9.6m (Fly Jib)
Max lifting height approx: 10.6m (fly Jib)
Rope length max: Variable
Dimensions folded: 2300mm (l) x 750mm (w) x 1930mm (h)
Weight unladen: 1750 kg / 1900 kg (with fly)
Point loadings Due to the many variables involved, point loadings are only available on request
Hook speed approx: Variable
Telescopic system boom length: 10.6m
  boom type: 5 section telescopic main boom plus 3 section hydraulic tele/luffing fly jib.
Derricking angle/speed approx: 395°
Traction system drive: Hydrostatic, step-less forward and reverse, remote control.
  travel speed: 0,9 Km/H (1st gear) 2,0 Km/H (2nd gear)
  gradability: Ground conditions dependent
  track ground length: 1.23m
  track ground pressure: 48kPa (0.49kg/cm2)
  track width: 0.18m
Engine manufacturer: Yanmar L100N6
  fuel: Diesel / single phase mains voltage
  starting method: Electric and recoil start as standard
  tank capacity: 8 litres
Electric motor power: 2,2kw
Electric motor voltage: 230 V
Standard equipment computer-controlled moment limiter (safe load indicator), overload warning lamps, radio remote control, mains electric dual power (230v), diesel engine
Standard equipment overwinding alarm, computer-controlled intelligent voice warning system, radio remote control
Operational equipment 2 fall hook block, 1 fall hook block, LPG dual power, mains electric dual power (230v), low marking tracks.

 

Telephone
+44 (0)1767 677155